VA800A-SPI Datasheet PDF - Bridgetek

●The VA800A-SPI is an USB 2.0 high-speed to MPSSE SPI Module, small electronic circuit board, utilising the FTDI FT232H. The 10-pin connector on the module fits directly to the FTDI VM800B and VM800C graphic display modules. This allows direct control of the EVE FT800 devices with an SPI interface from a USB host. All USB signalling and protocols are handled on the module. The VA800A-SPI MPSSE module is configured for SPI only. The 10-pin connector fits to the VM800B and VM800C graphic display modules directly.

● USB 2.0 high-speed (480Mbps) and full speed (12Mbps) compatible

● Entire USB protocol handled on the chip - No USB-specific firmware programming required

● USB type-B micro connector

● USB bus powered

● Synchronous serial (MPSSE) data rates of up to 30Mbps on SPI

● 1kb receive and transmit buffers for high data throughput

● 3.3V level IO

● Power indicator LED

● SPI SS# active indicator LED

● Adjustable receive buffer timeout

● Support for USB suspend and resume

● Low operating and USB suspend current

● Low USB bandwidth consumption

● UHCI/OHCI/EHCI host controller compatible

● -40 to +85°C Operating temperature range

● FTDI chip"s royalty-free D2XX drivers eliminate requirement for USB driver development in most cases