SC16IS740IPW,112 Datasheet PDF - NXP

●The SC16IS740IPW,112 is a single UART IC, provides slave I²C-bus/SPI Interface to a single-channel high performance UART. It offers data rates up to 5Mbps and guarantees low operating and sleeping current. This family of products enables seamless protocol conversion from I²C-bus or SPI to and RS-232/RS-485 and are fully bidirectional. Its internal register set is backward-compatible with the widely used and widely popular 16C450. This allows the software to be easily written or ported from another platform. It also provides additional advanced features such as auto hardware and software flow control, automatic RS-485 support and software reset. This allows the software to reset the UART at any moment, independent of the hardware reset signal.

● Single Full-duplex UART

● Selectable I²C-bus or SPI Interface

● 3.3 or 2.5V Operation

● 64-byte FIFO (Transmitter and Receiver)

● Fully Compatible with Industrial Standard 16C450 and Equivalent

● Baud Rates up to 5Mbps in 16x Clock Mode

● Auto Hardware Flow Control Using RTS/CTS

● Auto Software Flow Control with Programmable Xon/Xoff Characters

● Single or Double Xon/Xoff Characters

● Automatic RS-485 Support (Automatic Slave Address Detection)

● RS-485 Driver Direction Control Via RTS Signal

● RS-485 Driver Direction Control Inversion

● Built-in IrDA Encoder and Decoder Interface

● Software Reset

● Transmitter and Receiver can be Enabled/Disabled Independent of Each Other

● Receive and Transmit FIFO Levels

● Programmable Special Character Detection

● Line Break Generation and Detection

● Internal Loopback Mode

● Sleep Current less than 30µA at 3.3V