MCB1857UME Datasheet PDF - KEIL

●MCB1857UME evaluation board enables user to create and test working programs based on NXP LPC1857 family of ARM Cortex-M3 processor based devices with ULINK-ME debug adapter. The NXP LPC1857 MCU is a high end LPC devices with on chip CAN, Ethernet, USB connectivity. A 12.0MHz oscillator provides the clock signal for the MCU. The JTAG/Cortex Debug Interface connector provides debugging and emulator support for the LPC1850 device. The JTAG/Cortex Debug Interface allows application debugging and programming of on chip and off chip Flash devices. The board connects the on chip serial UARTs to the ST3232C, which converts the logic signals to RS232 voltage levels. The Ethernet Interface on the board provides a standard RJ45 connector with integrated transformer, and a 10/100 Ethernet 3.3V transceiver connected to the LPC1800 via the RMII interface. The ULINK-ME connects user PC"s USB port to target system and allows to program and debug embedded programs on the target hardware.

● 180MHz ARM Cortex-M3 processor based MCU in LBGA256

● On chip SRAM 136KB and On chip Flash 1MB dual bank

● On board memory of 16MB NOR Flash, 4MB quad SPI Flash, 16MB SDRAM, & 16KB EEPROM

● Colour QVGA TFT LCD with touch screen

● 10/100 Ethernet port

● High speed USB 2.0 Host/Device/OTG interface (USB host + Micro USB Device/OTG connectors)

● Full speed USB 2.0 Host/Device interface (USB host + micro USB Device connectors)

● CAN interfaces, MicroSD card interface

● Serial/UART port

● Audio CODEC with line in/Out and microphone/headphone connector + speaker