●The DS22EV5110-EVKC CAT5 / CAT6 Cable Extender Demo Kit provides a complete HDMI system extension solution with cost effective CAT5 or CAT6 cables, using Nationals DS22EV5110 - a DVI, HDMI Extended Reach Equalizer with Retimer and Output De-Emphasis.
●The kit consists of following boards for different application needs:
●The DS22EV5110 receiver board has two RJ45 jacks as the inputs and one HDMI female receptacle connector as the output.
●The passive adapter board has two RJ45 jacks and one HDMI female receptacle connector, can be either the input(s) or the output(s).
●The DS22EV5110 on the boards equalizes the long reach HDMI or CAT5 cable at the input, then sends out the low jitter TMDS signal to the HDMI cable through output.
●All the TMDS signals are connected through one RJ45 jack between two boards.
●The DDC signals are connected through an I2C buffer; the Hot Plug, 5V Power and 5V Ground are directly connected between the connectors, making this demo kit HDCP compliant.
●A 3.3V VCC 1-pin header and a GND 1-pin header are used for the power supply for the DS22EV5110 boards.
●Alternately, an AC/DC power adapter (>800mA) is required for each driver or receiver board of the evaluation kit to provide 5V DC voltage for easy portability. A 1.8mm DC Power Jack is used to connect the AC/DC Power Adapter. Nationals LP3965, a 3.3V, 1500mA, Fast, Ultra Low Dropout Linear Regulator, converts the 5V power supply voltage to a 3.3V power supply voltage that powers the DS22EV5110.
