65240-003LF Datasheet PDF - FCI Electronics

●The DUBOX 65240 series Connector families offer an extensive range of through-hole and surface-mount part options, including either straight or right angle orientation from 2 to 50 positions, with a current rating of 3A (maximum) per individual contact. The Dubox® contact has a pre-stressed, dual beam design to enable low insertion force, 4-wall contact design for signal protection. These are applicable in electronic equipment or devices requiring a parallel, planar or perpendicular board-to-board, wire to-board or flat cable interconnects. Uses span industry segments.

● Dual beam contact design

● Contact pre-stressed

● Mates with very short pins (5mm) stackable end-to-end and side-by-side

● Floating solder tails self centre on the circuit pads

● 4 wall contact design

● Duplex plating

● High reliable electrical performances

● Low insertion force required

● Meets your specific needs and is useful for Mezzanine Application

● Easy to assures the coplanarity

● Signal protection

● Maintaining the alignment for soldering and facilitates robotic placement

● Compatible with infrared and vaporphase reflow